about faq contact us log in / register

8 steps to setup BMW Rheingold ISTA on ICOM emulator



up vote 0 down vote favorite
Here is a step-by-step guide of configuring BMW ICOM Rheingold ISTA-D ISTA-P diagnostic & programming software on BMW ICOM A2+B+C diagnostic system. Tool needed: BMW ICOM a2+b+c diagnostic tool with WIFI ICOM Rheingold software HDD NOTE: As for BMW ICOM Rheingold software, we recommend 2015.1V Rheingold ISTA-D 3.47 ISTA-P 54.3 software HDD which performs more stable. Instruction: The configuration is based on Virtual Machine. 1. Open used for connection network adapter properties, then “Internet Protocol Version 4 (TCP/IPv4)” properties, then enter 169.254.1.1 for “IP address” and 255.255.0.0 for “Subnet mask” 8 steps to setup BMW Rheingold ISTA on ICOM emulator-1 If VMware is installed, open Virtual Network Editor and disconnect from the host any adapters with Subnet address 169.254.0.0 8 steps to setup BMW Rheingold ISTA on ICOM emulator-2 Open C://EDIABAS/BIN/EDIABAS.INI with Notepad and check for “Port=6801” in TCP settings. 8 steps to setup BMW Rheingold ISTA on ICOM emulator-3 Set up ICOM A, ICOM B and ICOM C emulators, and connect BWM ICOM with vehicle and PC. 8 steps to setup BMW Rheingold ISTA on ICOM emulator-4 Run BMW ICOM Rheingold ISTA-D ISTA-P software shortcut on start menu, wait until it boots, then press “Settings” icon the top of the program 8 steps to setup BMW Rheingold ISTA on ICOM emulator-5 Select “VCI Config” (VCI Configuration) Tab and tick “HO-ICOM/ENET local and ISISnetwork”, press “OK” 8 steps to setup BMW Rheingold ISTA on ICOM emulator-6 Go to “Operations” menu, the “Read Out Vehicle Data” and “Complete Identification” 8 steps to setup BMW Rheingold ISTA on ICOM emulator-7 8 steps to setup BMW Rheingold ISTA on ICOM emulator-8 Select ICOM connection from the list and press “Set up connection” button. The Rheingoldis detecting vehicle and vehicle identification is in progress. 8 steps to setup BMW Rheingold ISTA on ICOM emulator-9 8 steps to setup BMW Rheingold ISTA on ICOM emulator-10 Configuration is done. Start running software and diagnose/program BMW cars.
link | flag

Your Answer